Renewing cables for sunroof sun blind: Audi Q3

🧭 Before you start

Fits: Audi Q3 (8U, 2011–2018); platform code 84

Don't miss

• When installing, make sure that actuators run parallel.
• Illustration shows view from underneath.

📋 Procedure

1. Sunroof frame removed
2. Sunroof roller blind control unit J394 removed
3. Cross strut for sunroof sun blind removed
4. Sunroof sun blind removed
5. Pull cable out of frame towards rear.

6. When installing, make sure that actuators run parallel.
7. Draw cables into frame on both sides.
8. Insert cover (1) and secure with bolt.
9. Slide cables on both sides towards rear as far as stop on cover (1) and install sunroof roller blind control unit J394.
10. Engage tensioning strap (3) of sunroof sun blind in actuators (2) of cable. [Note: Illustration shows view from underneath.]
11. Perform adaption .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing seat belts of 3-person bench seat, Multivan
• Removing and installing belt buckles of 3-person bench seat, Transporter
• Removing and installing right dash panel trim, Transporter
• Removing and installing front side panel trim, Multivan
• Removing and installing rear side panel trim, hardboard-type, Transporter