Removing and installing battery monitoring control unit — AUDI
Removing and installing battery monitoring control unit on Audi: 6 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Transporter T5 (7H), VW Transporter T5 (7J), VW Transporter T6 (7E), VW Transporter T6 (7F)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 6 Nm (4.4 lb-ft) | Tighten battery negative terminal clamp securing nut (1) |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off ignition and all electrical loads, and pull out ignition key.
- Release and disconnect connector (A) on battery monitor control unit J367.
- Loosen clamping bolt (arrow) on negative battery terminal and remove negative terminal from battery.
- Undo and remove bolts (arrows) from coolant reservoir and place reservoir to one side together with connected lines.
- Unscrew nut of negative cable (arrow).
- Remove negative battery cable together with battery monitoring control unit from the engine compartment.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing relay carrier in seat box at front on left · 1 torque figures
- Removing and installing coupling station in seat box at front on left · 1 torque figures
- Removing and installing dash panel middle trim, Multivan
- Removing and installing seat belt for outer seat in 3rd row, Transporter
- Removing and installing trim on front passenger side, Transporter
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.