Removing and installing trim on front passenger side, Transporter — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T5 (7J), VW Transporter T6 (7E), VW Transporter T6 (7F)

Don't miss

• During assembly, check that the four screws (1) are installed as instructed with a specified torque of 1.5 Nm.

📋 Procedure

1. Switch ignition on.
2. Disconnect vehicle battery Electrical system27Disconnecting and reconnecting battery.
3. Remove right-hand dash panel side cover .
4. Remove right dash panel trim .
5. Remove right footwell cover .

6. Remove right dash panel trim .
7. Remove fresh air blower V2Heating80Removing fresh air blower -V2-.
8. Remove front passenger side airbag unit .
9. Remove the 4 bolts (1).
10. Detach retaining strap (2) from dash panel.
11. Using wedge T10039/1, lever out trim (3) from mountings on front passenger side, starting from bottom.
12. Remove trim on front passenger side. [Note: During assembly, check that the four screws (1) are installed as instructed with a specified torque of 1.5 Nm.]
13. Switch ignition on.
14. ⚠ Ensure that nobody is in vehicle. — Reconnect battery earth strap Electrical system27Disconnecting and reconnecting battery.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures