Removing and installing aerial module, right R109 (Avant) — AUDI

🧭 Before you start

Fits: Audi A4 B6/B7 (8E)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off all electrical equipment.
2. Remove ignition key.
3. Remove the bass loudspeaker R100.
4. Unscrew bolts (arrows) (7 Nm) on bracket for aerial module, right R109. — 7 Nm (5.2 lb-ft)
5. Unplug electrical connectors at right aerial module R109.
6. Unscrew bolts (arrows) (2 Nm) and remove aerial module, right R109 from bracket. — 2 Nm (1.5 lb-ft)
7. Installation is performed in reverse sequence.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing airbag control unit J234, Multivan
• Removing and installing airbag unit on driver side (3-spoke steering wheel)
• Removing and installing curtain airbag in rear passenger compartment, Multivan
• Removing and installing rear side panel trim, vehicles without sliding door on driver side · 1 torque figures
• Removing and installing seat adjustment control element