Removing and installing aerial amplifier 3R112/aerial amplifier 4 for TVR85, Avant — AUDI

🧭 Before you start

Fits: Audi A6 C6 (4F, 2004–2011)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off all electrical equipment.
2. Remove ignition key.
3. Remove rear lid trim General body repairs, interior70.
4. Unplug all connectors on aerial amplifier 3R112(1).
5. Unscrew bolt (1) (2 Nm) and detach the aerial amplifier 3R112(1) from the rear lid. — 2 Nm (1.5 lb-ft)
6. Installation is performed in reverse sequence.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking air recirculation valve for turbocharger N249 - vehicles with electronic throttle
• Installing gearbox - vehicles with 4-cylinder or 6-cylinder engine
• Dismantling and assembling triple roller joint AAR 3300 i
• Removing and installing selector lever cable (vehicles up to VIN 8E_6A156499) · 1 torque figures
• Removing and installing heating and air conditioning unitVX1, "“Climatronic”" · 1 torque figures