Removing and installing aerial amplifier for mobile phone R86 (Avant) — AUDI

🧭 Before you start

Fits: Audi A6 C5 (4B)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off all electrical equipment.
2. Remove ignition key.
3. Remove luggage compartment side trim (left-side): General body repairs, interior70.
4. Remove entire mounting frame.
5. Swivel the rear side to front and unbolt aerial amplifier for mobile telephone R86(1) (2 Nm). — 2 Nm (1.5 lb-ft)
6. Unplug connectors at aerial amplifier for mobile telephone R86.
7. Installation is performed in reverse sequence.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing fuel tank with attachments
• Removing and installing power-assisted steering box (right-hand drive)
• Removing and installing vane pump (vehicles with 6-cyl. TDI engine)
• Checking data exchange between engine control unit and connected control units
• Connecting adapter V.A.G 1598/20 (test box) to automatic gearbox control unit J217