Removing and installing aerial filter (GPS)R110 (Saloon) — AUDI
Removing and installing aerial filter (GPS)R110 (Saloon) on Audi: 11 steps, 2 torque figures. What to remove, what to tighten and to how many Nm, what to.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A6 C5 (4B)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 1 Nm (0.7 lb-ft) | If the housing needs to be removed, loosen bolts (1 |
| 3 Nm (2.2 lb-ft) | Loosen nut for retaining plate (arrow |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off all electrical equipment.
- Remove ignition key.
- Remove luggage compartment side trim (left-side): General body repairs, interior70.
- Remove entire mounting frame.
- Unplug connectors and take out mounting frame together with devices.
- Loosen nut for retaining plate (arrow) (3 Nm) and disengage retaining plate at lugs (1). — 3 Nm (2.2 lb-ft)
- Open housing for aerial filter (GPS)R110(arrow).
- Remove aerial filter (GPS)R110 from housing.
- Unplug connectors at aerial filter (GPS)R110.
- If the housing needs to be removed, loosen bolts (1) (1 Nm). — 1 Nm (0.7 lb-ft)
- Installation is performed in reverse sequence.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing hydraulic pressure line between gearshift actuator and hydraulic unit for R tronic
- Renewing connection on gearshift actuator for R tronic
- Removing and installing gear oil lines (front) - vehicles with gear oil cooling
- Removing and installing cross piece connecting rollover bar
- Removing and installing control unit for seat belt microphone J886
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.