Removing and installing gear oil lines (front) - vehicles with gear oil cooling — AUDI

🧭 Before you start

Fits: platform code 42

• Opens: gearbox oil

Don't miss

• Seal off open lines and connections with clean plugs or sealing caps to prevent dirt from entering.(Arrow) can be disregarded.
• (Arrows) can be disregarded.

📋 Procedure

1. Remove rear wheel (right-side) Wheels and tyres44.
2. Remove rear wheel housing liner (right-side) General body repairs, exterior66.
3. Place used oil collection and extraction unitV.A.G 1782 below connection.
4. Unscrew union nuts (1) and (2). [Note: Seal off open lines and connections with clean plugs or sealing caps to prevent dirt from entering.(Arrow) can be disregarded.]
5. Remove air duct (1)(arrows).

6. Remove bolt (2).
7. Remove nut (1) and detach retaining plate.
8. Remove bolt (2) on bracket for oil line.
9. Place used oil collection and extraction unitV.A.G 1782 below connection.
10. Unscrew union nuts (3) and (4) and detach gear oil lines (front). [Note: (Arrows) can be disregarded.]
11. Install rear wheel housing liner (right-side) General body repairs, exterior66.
12. Fit rear wheel (right-side) Wheels and tyres44.
13. Check gear oil level and top up as required .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing trim (sill side) - bucket seat – Audi
• Adjusting backrest locking switch unit (microswitches) – Audi
• Removing and installing oil pump from engine number CAUA 003 686 onwards
• Removing and installing intake manifold (bottom section) with fuel rail - plastic intake manifold (gradual introduction in model year 2009)
• Renewing guide link bush – Audi A6 C6