Removing and installing activated charcoal filter - NAR vehicles — AUDI

🧭 Before you start

Fits: Audi Q3 (8U, 2011–2018); platform code 84

🔧 Engine codes this applies to

📋 Procedure

1. Observe safety precautions .
2. Observe rules for cleanliness .
3. Remove rear wheel housing liner (right-side) General body repairs, exterior66Wheel housing liners; Removing and installing wheel housing liner (rear).
4. Disconnect breather lines (1 and 3) at activated charcoal filter. Disconnecting plug-in connectors
5. Detach leak diagnosis line (2) at diagnostic pump.

6. Unplug electrical connector (2).
7. Unscrew nuts (3) and detach activated charcoal filter from studs.
8. Press in retaining hook with a screwdriver and pull activated charcoal filter (1) downwards out of retainer (arrow).
9. Remove bolt (3).
10. Disengage air filter (1) at activated charcoal filter (arrow).
11. Release hose clip and detach vent hose (2).
12. Remove bolts (4).
13. Release hose clips and detach vent hoses (1 and 3).
14. Detach diagnostic pump (2).
15. Connect breather lines, making sure they engage audibly.
16. Press breather lines in again and then pull to check that plug-in connectors are correctly engaged.
17. Install rear wheel housing liner General body repairs, exterior66Wheel housing liners; Exploded view - wheel housing liner (rear).

Other AUDI procedures

• Removing cylinder head - vehicles without hybrid drive
• Removing and installing coolant circulation pump V50 · 1 torque figures
• Removing and installing catalytic converter – Audi A1
• Removing and installing torque reaction support and cross member
• Exploded view - drive chain for balance shaft · 2 torque figures
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures