Removing and installing continued coolant circulation pump V51 — VW

🧭 Before you start

Fits: VW Jetta VI (16, 2010–2018)

• Opens: coolant
• Special tools named: 3094

🔧 Engine codes this applies to

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Open filler cap (arrow) of coolant expansion tank.
2. Drain coolant .
3. Remove engine cover panel .
4. Remove air filter housing .
5. Loosen hose clamps (3) and (5).

6. Disconnect connector for charge pressure sender G31(arrow).
7. Unscrew bolts (1) and (4), and remove air pipe downwards.
8. Remove coolant hose (1) from thermostat.
9. Disconnect connector (arrow) for continued circulation coolant pump V51(1).
10. Unscrew nut (3) and remove continued coolant circulation pump V51(1) from bracket (2).
11. Clamp off coolant hoses (1) on continued coolant circulation pump V51(2) using hose clamps up to 25 mm in diameter 3094.
12. Release hose clips (arrows) and detach coolant hoses (1).
13. Check coolant level .

Other VW procedures

• Removing and installing air mass meter G70 – Audi A6 C6
• Removing and installing exhaust gas pressure sensor 1G450
• Bleeding fuel system and checking for leaks – Audi Q7
• Checking tandem pump – Audi A6 C5
• Removing and installing oil cooler
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures