Removing and installing accelerator pedal module with accelerator position sender G79/G185 (version 2) — AUDI

🧭 Before you start

Fits: Audi TT Mk2 (8J, 2006–2014)

Don't miss

• Disregard (item 1).

🔧 Engine codes this applies to

📐 56 workshop diagrams for BPY

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Remove cover for steering column (arrows).
2. Pull out release tab (2) as far as stop in direction of (arrow) and unplug electrical connector (1) at accelerator pedal module (3).
3. Use screwdriver to prise off cap (4).
4. Remove bolt (5).
5. Push release tool T10238 (or release tool T10240 for RHD vehicles) fully into the slots provided, as illustrated (arrow), and detach accelerator pedal module.

6. Plug in electrical connector (2) at accelerator pedal module (5).
7. Press accelerator pedal module onto retaining studs (6).
8. Insert centring pin (7) into hole in underbody.
9. Secure accelerator pedal module with bolt (3) and press on cap (4). [Note: Disregard (item 1).]
10. After renewing, perform kick-down adaption in "“Guided Functions”" mode .

Other AUDI procedures

• Removing and installing oil filter bracket – VW · 3 torque figures
• Removing and installing fuel filter – Audi R8 · 1 torque figures
• Removing and installing sealing flange (pulley end) – Audi
• Removing and installing air cleaner housing – Audi A6 C5 · 1 torque figures
• Checking injection quantity and spray pattern of injectors; checking for leaks · 1 torque figures
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures