Pulling rear wheel bearing out and in with assembly tool3253 — AUDI

🧭 Before you start

Fits: platform code 7DA

Don't miss

• Loosen hexagon bolt for drive shaft when vehicle is standing on its wheels (otherwise danger of accident).

📋 Procedure

1. Loosen hexagon bolt for drive shaft when vehicle is standing on its wheels (otherwise danger of accident).
2. Remove wheel and raise vehicle.
3. Remove bolt securing wheel bearing.
4. Remove drive shaft .
5. Remove ABS speed sensor from wheel bearing housing.

6. Remove handbrake cable from brake caliper.
7. Remove brake caliper and tie to body with wire.
8. Remove brake disc and cover plate.
9. Pull wheel hub out of wishbone.
10. Remove circlip.
11. Pull wheel bearing out of wishbone.
12. Pull bearing inner race off wheel hub.
13. Pull wheel bearing into wishbone to stop.
14. Install circlip.
15. Pull wheel hub in to stop.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing anti-roll bar (multi-link suspension - four-wheel drive vehicles)
• Removing and installing earth cable with battery monitor control unit J367 - battery in engine compartment
• Removing and installing earth cable with battery monitor control unit J367 - battery in luggage compartment
• Removing and installing starter - vehicles with 1.2 ltr, 1.4 ltr. and 1.8 ltr TFSI engine and manual gearbox
• Removing and installing bracket for adaptive cruise control unit J428 - version 3