Removing and installing bracket for adaptive cruise control unit J428 - version 3 — AUDI

🧭 Before you start

Fits: Audi A3 (8V, 2012–2020); platform code 85

• Special tools named: VAS 6335

Don't miss

• If the same adaptive cruise control unit is being re-installed, the clips on the adaptive cruise control unit must be renewed .

📋 Procedure

1. Remove adaptive cruise control unit .
2. Remove sealing plug (2).
3. Release retaining tabs (arrows).
4. Pull cover (1) off adaptive cruise control unit J428(item 3).
5. Set control unit down on a soft and clean surface.

6. Remove studs (arrows) alternately.
7. Remove bracket (2) from adaptive cruise control unit J428(item 1). [Note: If the same adaptive cruise control unit is being re-installed, the clips on the adaptive cruise control unit must be renewed .]
8. Position bracket on control unit using stud.
9. Screw stud into adaptive cruise control unit as far as dimension (a).
10. Use digital caliper VAS 6335 to measure dimension (a) on all studs and adjust if necessary.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing front side panel trim, Multivan
• Removing and installing rear side panel trim, hardboard-type, Transporter
• Removing and installing backrest of 3-person bench seat, Transporter
• Removing and installing rollers and support, table module in seat rails
• Removing and installing table module in side panel