Fitting on backrest cover for single folding seat — AUDI

🧭 Before you start

Fits: platform codes 70A, 7DA

📋 Procedure

1. Make four tensioning wires (2 mm ∅) with the dimensions: (a) = 360 mm, (b) = 320 mm.
2. Make one tensioning wire (2 mm ∅) with the dimensions: (a) = 320 mm, (b) = 280 mm.
3. Introduce the prepared tensioning wires (2 mm ∅) into the looped straps of the seat cover. (1) = 280 mm, (2) = 320 mm
4. Place backrest cover onto backrest upholstery.
5. Clip tensioning wires (1) and (2) tight to upholstery wire (arrows) using the upholstery pliersV.A.G 1634.
6. Pull backrest cover over backrest upholstery.
7. Close zipper (1).
8. Insert the two prepared tensioning wires into the hem loops (arrows) and tack together with upholstery clips.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking intake manifold temperature sender G72
• Renewing refrigerant line between air conditioner compressor and condenser · 1 torque figures
• Removing and installing high-pressure sender -G65- · 1 torque figures
• Removing and installing auxiliary heater
• Removing and installing front section of centre console, panel van