Removing and installing front section of centre console, panel van — AUDI

🧭 Before you start

Fits: VW Caddy III (2K, 2004–2015); platform code 2C0

📋 Procedure

1. Switch off ignition.
2. Separate gear shift gaiter from cover 6-speed manual gearbox 02Q34Repairing gear change mechanism.
3. Remove selector lever cover Direct shift gearbox 02E - 6-speed34Overview of gear change mechanism.
4. Remove lining mat (1) and unscrew bolt (2).
5. Pull front compartment (3) out of mountings and disconnect wiring harnesses (4) depending on vehicle equipment.

6. Open ashtray, remove cigarette lighter trim (1) and cover cap (2).
7. Unscrew bolts (3) and (4).
8. Release ashtray from centre console and disconnect wiring harness (5) from cigarette lighter.
9. Open storage compartment on driver side and unscrew 2 bolts (1).
10. Unscrew bolt (2) in front passenger footwell.
11. Remove the three bolts (1).
12. Unscrew bolt (2).
13. Move gearstick or selector lever to rearmost position.
14. Remove cover from vehicle.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking probe heating for Lambda probes – Audi A6 C5 2.7
• Removing and installing bottom coolant pipe - vehicles with engine code letters AJM
• Removing and installing catalytic converter and exhaust pipe - vehicles with engine code letters AJM
• Checking activated charcoal filter system solenoid valve 1N80
• Removing and installing clutch slave cylinder on vehicles with 4-cylinder engine and 6-cylinder TDI engine