Removing and installing high-pressure sender -G65- — AUDI

🧭 Before you start

Fits: VW Caddy III (2K, 2004–2015); platform code 2C0

Don't miss

• Always renew O-ring (2).Depending on engine version, the high-pressure sender G65(1) may be installed in another location near the condenser.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove lower engine cover.
2. Disconnect connector from high-pressure sender (1).
3. Unscrew high-pressure sender (1) out of refrigerant line connection. [Note: Always renew O-ring (2).Depending on engine version, the high-pressure sender G65(1) may be installed in another location near the condenser.]
4. Tighten high-pressure sender (1) to 8 Nm. — 8 Nm (5.9 lb-ft)

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Audi 2.5 TDI gearbox removal & installation · 2 torque figures
• Determining total shim thickness "“S"total” (S1 plus S2) · 2 torque figures
• Silencers - exploded view · 4 torque figures
• Audi 2.0 A4 ALT radiator removal
• Connection points · 4 torque figures