Exploded view - intake manifold (bottom section) with fuel rail — AUDI

🧭 Before you start

Fits: Audi A6/A7 C7 (4G, 2011–2018); platform code 4X

🔧 Engine codes this applies to

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Tighten bolts and nuts (arrows) in stages (final torque 9 Nm). — 9 Nm (6.6 lb-ft)
2. Tighten bolts and nuts (arrows) in stages (final torque 9 Nm). — 9 Nm (6.6 lb-ft)
3. Tighten bolts (arrows) in diagonal sequence to 10 Nm. — 10 Nm (7.4 lb-ft)
4. Tighten bolts in stages as follows:

Other AUDI procedures

• Exploded view - sump/oil pump · 22 torque figures
• Securing engine to engine and gearbox support · 18 torque figures
• Exploded view - timing chain cover · 18 torque figures
• Exploded view - crankshaft · 13 torque figures
• Removing and installing timing chain cover (bottom) – Audi · 7 torque figures
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures