Exploded view - cylinder head without AVS — AUDI

🧭 Before you start

Fits: Audi TT Mk2 (8J, 2006–2014)

• Special tools named: torque wrench, feeler gauge

🔧 Engine codes this applies to

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Tighten bolts for crankcase breather system in the sequence (1 ... 10) to 11 Nm. — 11 Nm (8.1 lb-ft)
2. Remove bolts (arrows).
3. Slacken cylinder head bolts in the sequence (1 ... 5).
4. Tighten cylinder head bolts in the sequence (1 ... 5) as follows:
5. Tighten with torque wrench initially to 40 Nm. — 40 Nm (30 lb-ft)

6. Use rigid wrench to turn 90° further.
7. Use rigid wrench to turn 90° further.
8. Pre-tighten bolts (arrows) to 8 Nm. — 8 Nm (5.9 lb-ft)
9. Turn bolts (arrows) 90° further using a rigid wrench.
10. Use straight edge and feeler gauge to measure cylinder head for distortion at several points.

Other AUDI procedures

• Checking holding pressure, vehicles with fuel filter integrated into flange of fuel delivery unit
• Removing and installing balance shaft (inlet side) – Audi Q3
• Checking fuel pump delivery rate (front-wheel drive) – Audi
• Removing and installing fuel pressure sender G247 · 1 torque figures
• Removing and installing upper timing chain cover – VW · 1 torque figures
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures