Exhaust system - exploded view of components — AUDI
Exhaust system - exploded view of components on Audi: 5 steps, 3 torque figures, engines AKE, ALZ, AMU, ANY.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A2 (8Z)
- Special tools named: torque wrench
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 23 Nm (17 lb-ft) | Tighten bolt (1) |
| 23 Nm (17 lb-ft) | Tighten bolt (2) |
| 25 Nm (18 lb-ft) | Tighten clamp connection (2) |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Install clamp so that bolts are positioned horizontally (arrow).
- Screw in bolt (1) finger-tight.
- Screw in bolt (2) finger-tight.
- Tighten bolt (1) to 23 Nm with torque wrench. — 23 Nm (17 lb-ft)
- Tighten bolt (2) to 23 Nm with torque wrench. — 23 Nm (17 lb-ft)
Other AUDI procedures
- Removing and installing intermediate flange for turbocharger
- Removing and installing radiator fan V7 – Audi A6 C5
- Checking suction-jet pump – Audi A6 C5
- Removing and installing oil filter bracket - engine code letters AFB, AKN, AKE, AYM, BAU, BCZ, BFC
- Removing and installing mechanical exhaust gas recirculation valve - engine code letters AFB, AKE, AKN, AYM, BAU, BCZ, BFC
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.