Checking delivery pressure of power steering pump, vehicles with 4-cyl. petrol and diesel engine — AUDI

🧭 Before you start

Fits: Audi A6 C5 (4B)

• Renewed: power steering pump

📋 Procedure

1. Clamp off suction and return lines using hose clamps3094.
2. Unbolt expansion hose (1) from power steering pump.
3. Screw the adapterV.A.G 1402/3 into the power steering pump in place of the banjo bolt.
4. Screw the hose of the pressure gaugeV.A.G 1402 onto the adapterV.A.G 1402/3.
5. Close cut-off valve on pressure gauge (lever pointing to the left).

6. Detach the hose clamps up to 25 mm3094 and top up the fluid level in the reservoir if necessary.
7. Renew power steering pump if specification is not attained .
8. Switch off engine.
9. Check hydraulic fluid level .
10. Bleed steering system .
11. Checking steering system for leaks

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Installing oil return line with oil reservoir – Audi A6 C6 5.0
• Exploded view - dual-mass flywheel and sealing flange (gearbox end) · 1 torque figures
• Removing and installing mounting plate for engine oil cooler, pressure control valve for crankcase breather system and oil filter housing
• Removing and installing brackets for control motors V107 / V108 / V110, "“basic”" version
• Removing and installing brackets for control motors V110 / V299, "“deluxe”" version