Exploded view - dual-mass flywheel and sealing flange (gearbox end) — AUDI

🧭 Before you start

Fits: Audi A6 C6 (4F, 2004–2011)

Don't miss

• Disregard (items 7, 8).

🔧 Engine codes this applies to

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📐 66 workshop diagrams for CAGB

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Engage intermediate plate on sealing flange (top arrow) and push onto dowel sleeves (bottom arrows).
2. Tighten bolts (1 … 6) in 2 stages as follows:
3. Screw in by hand until contact is made.
4. Tighten in stages and in diagonal sequence; final torque 15 Nm. [Note: Disregard (items 7, 8).] — 15 Nm (11 lb-ft)

Other AUDI procedures

• Checking fuel pressure (low pressure) system – Audi A3 2.0 TDI
• Removing and installing Lambda probe – Audi R8
• Removing and installing fuel filter - vehicles with engine codes ASB, BHQ, BMK, BMZ, BNG, BPP, BSG
• Removing and installing radiator outlet coolant temperature sender G83
• Removing and installing accelerator pedal module with accelerator position sender G79/G185
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures