Checking delivery of plunger pump - Vehicles with 4-cyl. engine — AUDI

🧭 Before you start

• Renewed: tandem pump

📋 Procedure

1. Unscrew the pressure pipe from the pump (arrows) and route it upwards.
2. Screw the hose of the self-levelling suspension system tester V.A.G 1354 with the genuine banjo bolt and the metal seals N 013 808 3 to the pump.
3. Unscrew the cap from the reservoir.
4. Insert the end of the pipe of the self-levelling suspension system tester V.A.G 1354 in the reservoir.
5. Leave the engine idling until the pipe has been bled.

6. Switch off the ignition and hold the end of the pressure limiter pipe over a graduated beaker.
7. Leave the engine idling.
8. If the reading does not match the specification, replace the tandem pump.
9. Check the hydraulic fluid level (see the separate procedure).
10. Check the steering system for leaks (see the separate procedure).
11. Bleed the steering system (see the separate procedure).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Eliminating wiper judder - vehicles up to Model Year 2001
• Removing and installing filler neck with flexible pipe for washer fluid container
• Removing and installing washer fluid reservoir - vehicles with 1.2 l TDI engine
• Replacing main beam bulb – Audi A6 C5
• Replacing side light bulb – Audi A6 C5