Removing and installing washer fluid reservoir - vehicles with 1.2 l TDI engine — AUDI

🧭 Before you start

Fits: Audi A2 (8Z)

Don't miss

• The bumper has been removed in the illustration.

📋 Procedure

1. Detach the noise insulation (arrows).
2. Remove the left wheel housing liner (repair group 66).
3. Unclip the bleeder hose (1) at the holder (arrow).
4. Pull the flexible pipe (2) out of the washer fluid reservoir. [Note: The bumper has been removed in the illustration.]
5. Remove bolts (1) and (3).

6. Place a drip tray beneath the washer fluid reservoir.
7. Detach the washer fluid pipe (5) at the washer fluid pump.
8. Unplug the connector (4).
9. Lift the washer fluid reservoir (2) out of the guide ring.
10. If applicable, unplug the connector (arrow) at the washer fluid warning contact F77. [Note: The bumper has been removed in the illustration.]
11. Insert the bleeder hose (1) in the clip and measure the distance (a).
12. Fit the left wheel housing liner (repair group 66).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing front left/right adapter – Audi TT Mk1 · 2 torque figures
• Removing and installing aerial filter (GPS)R110 (Avant) – Audi · 2 torque figures
• Automatic gearbox 01M — Exploded view - ATF oil pan, valve body · 2 torque figures
• Dismantling and assembling triple roller joint AAR 2900 – Audi
• Removing and installing power steering pump (vehicles with 8-cyl. petrol engine with timing chain)