Adjusting short-travel selector mechanism: Audi A4 B5
Step-by-step adjusting short-travel selector mechanism for the Audi A4 B5: 14 steps, 3 torque figures.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A4 B5 (8D)
Don't miss
- The gear lever must remain in the same position while the bolt is being tightened.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 23 Nm (17 lb-ft) | Tighten bolt for selector rod |
| 23 Nm (17 lb-ft) | Tighten push rod bolt |
| 25 Nm (18 lb-ft) | Tighten nuts for ball housing: (arrow A) |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove gear knob and gear lever boot.
- Remove noise insulation for selector mechanism housing (arrows).
- Measure distance between body and rear push rod (in selector mechanism).
- If distance measured is not correct, adjust dimension (a) as follows:
- Loosen bolt (arrow 2) for push rod.
- Set to distance (a) by moving rear push rod (in selector mechanism).
- Tighten push rod bolt to 23 Nm. — 23 Nm (17 lb-ft)
- Loosen nuts for ball housing (arrow A) and (arrow B).
- Align ball housing horizontally.
- Tighten nuts for ball housing: (arrow A) to 25 Nm and (arrow B) to specified torque . — 25 Nm (18 lb-ft)
- Slacken bolt (arrow) for selector rod.
- Align gear lever so that it is angled slightly to the rear.
- Hold gear lever in this position (second mechanic required).
- Tighten bolt for selector rod to 23 Nm. [Note: The gear lever must remain in the same position while the bolt is being tightened.] — 23 Nm (17 lb-ft)
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing head restraint adjustment motor – Audi
- Removing and installing seat side padding and cover – Audi
- Checking CO2 content in auxiliary/additional heater exhaust gas
- Removing and installing selector mechanism - vehicles up to 05.99, vehicle ID No. 4B-X-130 000
- Removing and installing bottom coolant pipe - vehicles with engine code letters AVF, AWX
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.