5-speed Manual Gearbox 085 DS Self-diagnosis — Final control diagnosis — AUDI

🧭 Before you start

Fits: Audi A2 (8Z)

📋 Procedure

1. Apply handbrake fully.
2. Connect the vehicle diagnostic, testing and information system VAS 5051 A
3. Switch on ignition.
4. Touch the "“Guided fault-finding”" key.
5. Enter the vehicle identification by touching the applicable line of text (1) bearing in mind the selection prompt (A).

6. Wait until "“Control units have been interrogated”" appears in display zone (A). The corresponding vehicle systems are displayed with a black background in the display.
7. Touch → key.
8. Enter the function/component selection by branching to the electronic manual gearbox control unit J514 corresponding to the selection prompt (A).
9. Touch the applicable line of text (1) and the → key.
10. Continue following the instructions on the display of the vehicle diagnostic, testing and information system VAS 5051 A.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Testing electronic throttle warning lamp -K132
• Testing Motronic current supply relay -J271 - Vehicles from model year 2000 onwards
• Testing intake air temperature sender -G42
• Checking lambda probe heating -Z19 for lambda probe upstream of catalytic converter.
• Removing and installing toothed belt approx. 06.99 >