2.0/1.8 TFSi Generation II (CABA/CAEB/CAED/CPMB) Ancillary — AUDI

🧭 Before you start

Fits: platform codes 1.8, TFSI, |, 2.0, S3

• Timing position: the crankshaft or camshaft is set and locked during this job
• Special tools named: locking pin

Don't miss

• At removal, mark the direction of rotation; when refitting ensure the drive belt rotates in the same direction

🔧 Engine codes this applies to

📐 37 workshop diagrams for CABA

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Poly V-belt installation tool:
2. Note: At removal, mark the direction of rotation; when refitting ensure the drive belt rotates in the same direction
3. Turn the tensioner clockwise to release the belt tension
4. Lock the tensioner; use a locking pin
5. Remove the ancillary drive belt

6. Remove the tensioner locking pin
7. Note: Release the tensioner slowly
8. Check that tension is applied to the belt
9. Start the engine
10. Check for correct operation

Other AUDI procedures

• Checking fuel system pressurisation pump G6 - A5 from model year 2012 onwards, A4 with 4-cyl. and 6-cyl. engines from model year 2013 onwards, RS 5 from model year 2012 onwards, RS 4
• Removing and installing fuel pump control unit J538 - rest-of-world vehicles with front-wheel drive
• Removing and installing oil pressure switch for reduced oil pressure F378
• Removing and installing accelerator pedal module with accelerator position sender G79/G185
• Draining fuel tank - rest-of-world vehicles with four-wheel drive
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures