Removing and installing radiator fan V7: Audi A6 C5 (AFB, AJM, AKB, AKC, …)

🧭 Before you start

Fits: Audi A6 C5 (4B)

Don't miss

• Illustration shows vehicle from model year 2002 onwards.
• Fit all cable ties in the original position when installing.

🔧 Engine codes this applies to

📋 Procedure

1. On vehicles with auxiliary/additional heater, remove bolts (arrows) securing exhaust pipe for auxiliary/additional heater to noise insulation.
2. Release fasteners (1 ... 3) and (5) and take off front noise insulation. Leave rear noise insulation in position. [Note: Illustration shows vehicle from model year 2002 onwards.]
3. Remove front bumper General body repairs, exterior63.
4. Move lock carrier into its service position General body repairs, exterior50.
5. Remove engine cover panel:

6. Remove cover (arrow) at power steering fluid reservoir.
7. Remove electrical connectors (1) and (2) from bracket.
8. Detach electrical connector (2).
9. Lay wiring harness to radiator fan V7 clear.
10. Remove bolt (1).
11. Turn radiator fan V7 in direction of (arrow) and remove. [Note: Fit all cable ties in the original position when installing.]
12. Install lock carrier General body repairs, exterior50.
13. Install front bumper General body repairs, exterior63.

Other AUDI procedures

• Removing and installing oil pump – Audi A8 D3 · 5 torque figures
• Removing toothed belt from camshaft sprockets – Audi · 2 torque figures
• Removing sump (top section) – Audi A4 B5 · 2 torque figures
• Installing sump (top section) - engines with liquid gasket · 5 torque figures
• Removing and installing mounting bushes on bracket for power steering pump and oil cooler · 2 torque figures
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures