Types of securing bolts for injection pump belt pulley — VW
Types of securing bolts for injection pump belt pulley on VW: 4 steps, 2 torque figures, engines AGP, AGR, AHF, ALH.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Golf IV / Bora (1J)
- Renewed: securing bolts
Don't miss
- Securing bolt (A) is a stretch bolt and must always be renewed.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 20 Nm (15 lb-ft) | Specified torque for bolts |
| 25 Nm (18 lb-ft) | Torque setting of securing bolts |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Specified torque for bolts: 20 Nm + 1/4 turn (90°) further. — 20 Nm (15 lb-ft)
- Renew securing bolts. [Note: Securing bolt (A) is a stretch bolt and must always be renewed.]
- Torque setting of securing bolts: 25 Nm — 25 Nm (18 lb-ft)
- Securing bolts should not be renewed.
Other VW procedures
- Checking speed signal – VW Passat B5
- Checking charge pressure control solenoid valve N75 – VW
- Checking intake manifold flap motor V157
- Checking modulating piston movement sender G149
- Checking metering adjuster N146
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.