Three-point right-hand seat belt - 2 doors - change height — VW
Three-point right-hand seat belt - 2 doors - change height on VW: 4 steps, 2 torque figures. What to remove, what to tighten and to how many Nm, what to.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 6A1, 6A5
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 40 Nm (30 lb-ft) | Install the seat belt fastening screw |
| 40 Nm (30 lb-ft) | Open the cover (1)(arrow) and loosen the screw (3 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Open the cover (1)(arrow) and loosen the screw (3) (40 Nm). — 40 Nm (30 lb-ft)
- Remove the B-pillar lining cover (1) with the Nylon Wedge3409 or SpatulaVW 037.
- Install the cover with the hole facing upwards (position A) or downwards (position B), in the B-pillar lining (1).
- Install the seat belt fastening screw (40 Nm). — 40 Nm (30 lb-ft)
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing front seat drawer together with mounting · 1 torque figures
- Removing and installing cover and padding for "“2/3”" bench seat
- Removing and installing aerial module R108/R109 · 1 torque figures
- Removing and installing airbag unit on driver side week 45/2015 ►
- Removing and installing fastening rings – VW Golf Cabriolet · 1 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.