Tensioning V-belt on vehicles with 4-cylinder engine — VW
Tensioning V-belt on vehicles with 4-cylinder engine on VW: 4 steps, 3 torque figures. What to remove, what to tighten and to how many Nm, what to check.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform code 3A2
- Special tools named: V.A.G 1410, V.A.G 1410/2, torque wrench
Don't miss
- Nut (4) is only installed on petrol engines.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 25 Nm (18 lb-ft) | Tighten adjustment bolt clamping bolt (3) |
| 25 Nm (18 lb-ft) | Tighten hexagon bolt (2) and nut (4) |
| 45 Nm (33 lb-ft) | Tighten hexagon bolt (1) |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Tension V-belt by turning tensioning bolt with torque wrench (A) (V.A.G 1410 and V.A.G 1410/2).
- Tighten adjustment bolt clamping bolt (3) to 25 Nm. — 25 Nm (18 lb-ft)
- Tighten hexagon bolt (1) to 45 Nm. — 45 Nm (33 lb-ft)
- Tighten hexagon bolt (2) and nut (4) to 25 Nm. [Note: Nut (4) is only installed on petrol engines.] — 25 Nm (18 lb-ft)
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Checking fuel delivery rate of fuel system pressurisation pump G6
- Hydraulic unit, servo brake/ brake cylinder - assembly overview MK 20
- Hydraulic unit, servo brake/brake cylinder - MK 60 assembly overview
- Rear suspension (disc brake) - general overview of assembly
- Removing and installing wiper motor V
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.