Tail lights (Sedan) - remove and install — VW

🧭 Before you start

Fits: platform codes 9A2, 9A4, 9A5, 9A1, 9A3, 9A6

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Turn off the ignition, all the electrical devices, and remove the key from ignition.
2. Disconnect the BatteryA.
3. Remove the cover for access to the central tail light, located in the boot lid lining.
4. Disconnect the connector (1).
5. Loosen the securing nuts (arrows) (3 Nm). — 3 Nm (2.2 lb-ft)

6. Remove the lamp from the lid.
7. Move away the luggage compartment side lining (arrow)Bodywork - Internal assembly works70Lining / insulation, until enough space is freed to access the rear of the tail light.
8. Remove the lining of the indicated compartment (arrow) in order to access the lamp.
9. Disconnect the side tail light connector.
10. Loosen the securing nuts (arrows).
11. Remove the side tail light from the vehicle.
12. Installation is performed in reverse sequence to the removal.
13. Tighten the securing nuts of the lamp to a (3-Nm) torque.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Combined instrument K - remove and install · 3 torque figures
• Dashboard - align · 3 torque figures
• Fixing location of subframe, front-wheel drive, only Passat GTE · 2 torque figures
• VW Golf3, Vento 1.4, 1.6 timing belt replacement
• Transmission mount (EA 827 engine) - replace · 3 torque figures