Support with clutch pedal (without clutch transmitter cylinder) - remove and install — VW

🧭 Before you start

Fits: platform codes 6A1, 6A5

• Renewed: self-locking nuts

Don't miss

• Observe the fastening nut (2).
• The figure illustrates a support with clutch pedal (with the clutch transmitter cylinder installed). The hydraulic line of the clutch system must not be opened.
• Carefully pull the clutch pedal pin in order to ensure its proper fitting.

📋 Procedure

1. Remove the lower dashboard cover (driver side) General body repairs, interior68Internal equipment.
2. Remove the Clutch pedal switch F36
3. Remove the fastening bolt (1) and remove the impact absorption bar. [Note: Observe the fastening nut (2).]
4. Remove the clutch pedal pin (A) in the (direction of the arrow 1).
5. Remove the fastening bolts (arrows 2) of the clutch transmitter cylinder from the clutch pedal support.

6. Remove the clutch pedal support fastening nuts.
7. Remove the support with clutch pedal (without the clutch transmitter cylinder). [Note: The figure illustrates a support with clutch pedal (with the clutch transmitter cylinder installed). The hydraulic line of the clutch system must not be opened.] [Note: Replace the self-locking nuts.]
8. Install and tighten the clutch pedal support fastening nuts. Tightening torques, refer to .
9. Install and tighten the fastening bolts (arrows 1) of the clutch transmitter cylinder in the clutch pedal support.
10. Install the clutch pedal pin (A) of the clutch transmitter cylinder/impulser inside the clutch pedal, in the (direction of arrow 2).
11. Carefully pull the clutch pedal pin in order to ensure its proper fitting.
12. Install the impact absorption bar and tighten the fastening bolt (1). Tightening torque, see .
13. Install the Clutch pedal switch F36
14. Install the lower dashboard cover (driver side) Body - Internal assembly work68Internal equipment; Driver-side dashboard cover - remove and install.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• 6-speed dual clutch gearbox 02E Volkswagen R GmbH — Removing and installing bevel box, Golf 2009 ► with 2.0 l engine
• Removing and installing front seat fan V268, Passat CC 2009► and CC 2010►
• Removing and installing anti-theft engine control unit, Eos
• Removing and installing brake caliper FNR-G – VW
• Removing and installing starter, 3.6 l FSI engine, automatic gearbox