Steering column unit - remove and install — VW

🧭 Before you start

Fits: platform codes 6A1, 6A5

Don't miss

• After removing the steering column control unit J500, do not place the steering column over the contacts (arrows) .This will damage the contacts and the steering column will have to be completely replaced.

📋 Procedure

1. Remove the steering column .
2. Separate the connections (1) from the steering column control unit J500(2).
3. Remove the cover (1).
4. loosen the bolts (1).
5. Remove the bolts (2) and remove the steering column control unit J500(3). [Note: After removing the steering column control unit J500, do not place the steering column over the contacts (arrows) .This will damage the contacts and the steering column will have to be completely replaced.]

6. Place the steering column control unit J500(1) properly over the contacts (arrows) .
7. Screw the bolts (1).
8. Thread and tighten the bolts (2) to the tightening torque.
9. Tighten the bolts (1) to the tightening torque.
10. Place and fit the new cover (1)(arrows).
11. Install the steering column .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Checking Lambda probe and Lambda regulation – VW 1.6 AEH/AKL
• Differential - general overview of assembly
• Self-levelling suspension components and fitting locations
• Assembly overview - subframe, anti-roll bar, suspension links
• Fitting location overview - injection system