Steering column switch (SMLS) - E595 - remove and install — VW

🧭 Before you start

Fits: platform codes 6A1, 6A5

📋 Procedure

1. Turn off the ignition and all electrical devices, then remove the ignition key.
2. Disconnect the BatteryA .
3. Place the steering wheel in centre position (straight wheels).
4. Remove the steering wheel.Chassis, axles, steering48Steering.
5. Place the steering column, adjusting it to its lowest position, and lock the column using the locking lever.

6. Remove the steering column lining General body repairs, interior68Stowage compartment/covers; assembly overview - luggage compartment lining.
7. Release the fastening bolt (arrow) of the steering column switch (1) .
8. Pull the safety lock (2) upwards, in the direction of (arrow B) and disconnect the connector (1) from the steering column switch (3) .
9. Remove the steering column switch (3).
10. If the Steering angle sensor G85 is integrated to the Airbag coil contact and return spring w/ sliding ring F138, carry out the basic adjustment of the steering angle sensor.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Checking fuel pressure, vehicles with engine codes CWVA, CWVB, CHYA, CHYB
• Removing and installing brake servo, LHD vehicles, 3-cyl. 1.4 l diesel engine
• Removing and installing sliding sunroof frame
• Removing soft top cover – VW Golf Cabriolet
• Removing gearbox, CC 2012 ► with diesel engine, front-wheel drive, engine lifting eyes fitted »diagonally« on engine