Speed sensor on rear axle - remove and install — VW
Speed sensor on rear axle - remove and install on VW: 7 steps, 2 torque figures. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 9A2, 9A4, 9A5, 9A1, 9A3, 9A6
Don't miss
- Before installing the speed sensor, clean the internal hole surface and Lubricating puttyG 000 650 around the sensor. Refer to the Chemicals Manual
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 6.5 Nm (4.8 lb-ft) | Place the speed sensor (2) in the wheel roller bearing case and tighten the screw (1)with |
| 8 Nm (5.9 lb-ft) | Place the speed sensor in the shaft end hole and tighten the bolt |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Lift the vehicle.
- Disconnect connector (1) from the speed sensor cable and from the speed sensor.
- Loosen the bolt (2) from the shaft end.
- Disconnect the speed sensor from the axle end.
- Before installing the speed sensor, clean the internal hole surface and Lubricating puttyG 000 650 around the sensor. Refer to the Chemicals Manual
- Place the speed sensor in the shaft end hole and tighten the bolt to 8 Nm. — 8 Nm (5.9 lb-ft)
- Connect the speed sensor to the speed sensor cable.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Checking cooling output on vehicles with automatically controlled air conditioning system (without high-voltage system)
- Removing and installing curtain airbag with igniter, 2-door and 4-door models
- Removing and installing turbocharger, Sharan
- Assembly overview - drive chain for balancer shaft · 2 torque figures
- Removing and installing high-voltage wiring harness for drive motor
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.