Repairing headlight mounting: VW Sharan II / SEAT Alhambra
Step-by-step repairing headlight mounting for the VW Sharan II / SEAT Alhambra: 5 steps, 1 torque figure.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Sharan II / SEAT Alhambra (7N, 2010–)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 6 Nm (4.4 lb-ft) | Specified torque |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove front bumper .
- Separate damaged headlight mounting (3) from lock carrier (4) while ensuring a flat surface at the separating point.
- Fit pop rivet nut (5).
- Secure retainer (7) using bolt (6).
- Specified torque: 6 Nm — 6 Nm (4.4 lb-ft)
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Installing bevel box, CC 2012 ►, Passat 2011 ► with 3.6 l - V6 petrol engine
- Installing bevel box, Passat 2011 ► with 2.0 l petrol engine
- Removing and installing clutch pedal, Golf, Golf Estate
- Removing and installing clutch position sender G476, Polo
- Removing and installing alternator, petrol engine
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.