Renewing wiper motorV — VW

🧭 Before you start

Fits: platform code BE1

📋 Procedure

1. ⚠ There is a risk of damage to the bonnet and the wiper arms.Before operating the windscreen wiper system with open bonnet, ensure that there is sufficient space for the components to move. — Deactivate APP function of wiper motor .
2. Remove wiper frame .
3. Lever drive rod (4) off motor crank ball joint (2) using removal lever80-200.
4. Remove hexagon nut (1).
5. Pull motor crank (2) off wiper motor shaft.

6. Remove bolts (3).
7. Remove wiper motorV from wiper frame.
8. Connect electrical connector to wiper motorV.
9. Switch on ignition.
10. Actuate "“flick wipe”" function and allow wiper motorV to move to its end position.
11. Switch off ignition.
12. Disconnect connector.
13. Fit wiper motorV to wiper frame.
14. Screw in bolts (3).
15. Fit motor crank (2) to wiper motor shaft.
16. Screw in hexagon nut (1).
17. Align drive rod (4) parallel to motor crank (2).
18. Tighten hexagon nut (1).
19. Connect drive rod (4) to motor crank (2) at ball joint.
20. Install wiper frame .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Repairing ZF power assisted steering box
• Chain drive - Assembly overview
• Valve gear - Assembly overview
• Removing and installing map-controlled engine cooling thermostat F265
• Valve mechanism - repair