Renewing oil seal for rear propshaft output flange (transfer box installed) — VW
Renewing oil seal for rear propshaft output flange (transfer box installed) on VW: 12 steps. What to remove, in what order, and what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Touareg II (7P, 2010–2018)
Don't miss
- Be careful not to damage sealing surface of output shaft.Do not screw in sheet metal screw too far to avoid damaging bearing behind it.
📋 Procedure
- Remove rear propshaft .
- Pry off dust cap (A) using assembly lever (B).
- Punch hole in centre of radial oil seal using drift.
- Screw in self-tapping screw (4 mm diameter head) (arrow). [Note: Be careful not to damage sealing surface of output shaft.Do not screw in sheet metal screw too far to avoid damaging bearing behind it.]
- Pull out radial oil seal using puller T10055.
- Lightly oil outer circumference of new radial oil seal.
- Half-fill space between sealing lip and dust lip with sealing greaseG 052 128 A1.
- Drive in new radial oil seal to stop with thrust piece T10450, being careful not to cant radial oil seal.
- Drive on new dust cap (A) using assembly tool T10399 until it engages on shaft.
- Renew O-ring (A) and circlip (B).
- Install rear propshaft .
- Check oil level in transfer box .
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing rear side airbag crash sensors G256/G257
- Checking the fuel delivery rate of the fuel pump for delivery G6 (0.5 bar low-pressure fuel system)
- Removing and installing engine control unit J623, engine control unit with protective housing
- Rear wheel brake (One shot (wedge) system) - assembly overview
- Checking switchover of intake manifold flap – VW 2.8 TDI AUH
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.