Renewing number plate light bulb, from 07.05 — VW
Renewing number plate light bulb, from 07.05 on VW: 5 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 9C1, 1C1, 1Y7
Don't miss
- Do not touch bulb glass when fitting bulbs. Fingers leave traces of grease on the glass, which evaporate when the bulb is switched on and cause the glass to cloud over. — Tighten bolts to 2 Nm.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 2 Nm (1.5 lb-ft) | ⚠ Do not touch bulb glass when fitting bulbs |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- ⚠ Switch off ignition and all electrical consumers.Remove the ignition key. — Remove bolts (arrows).
- Remove lens of number plate light.
- Remove bulb.
- ⚠ Do not touch bulb glass when fitting bulbs. Fingers leave traces of grease on the glass, which evaporate when the bulb is switched on and cause the glass to cloud over. — Tighten bolts to 2 Nm. — 2 Nm (1.5 lb-ft)
- Check function of number plate light.
🎬 Related video tutorial
Independent AUTODOC tutorial for the same job, filmed on a different model (SHARAN 7M) — the technique carries over, the fasteners and figures on this page are the ones for your car.
How to change license plate light bulbs on VW SHARAN 7M TUTORIAL
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Assembling 1st to 4th gear output shaft up to gearbox date 25 10 9
- 5-speed manual gearbox 02R — Gearbox oil - check · 1 torque figures
- Ignition and starter switch - remove and install · 1 torque figures
- Intake manifold - remove and install
- Cylinder head - remove and install
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.