Removing and installing number plate light bulb: VW Polo 6R
Step-by-step removing and installing number plate light bulb for the VW Polo 6R: 6 steps, 1 torque figure.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Polo 6R (2009–2014)
Don't miss
- A small silver coloured anti-dazzle strip (arrow) is fitted in number plate light lens. When installing lens, it must always be towards bumper.When assembling number plate light, ensure lens seal is seated correctly.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 1.2 Nm (0.9 lb-ft) | Tighten securing bolts (arrows) |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off ignition and all electrical consumers and remove ignition key.
- Remove securing bolts (arrows) from number plate light.
- Remove lens with the bulb.
- Push contact plate in direction of (arrow) and remove bulb. [Note: A small silver coloured anti-dazzle strip (arrow) is fitted in number plate light lens. When installing lens, it must always be towards bumper.When assembling number plate light, ensure lens seal is seated correctly.]
- Tighten securing bolts (arrows) to 1.2 Nm torque. — 1.2 Nm (0.9 lb-ft)
- Check function of number plate light.
🎬 Related video tutorial
Independent AUTODOC tutorial for the same job, filmed on a different model (PASSAT B6) — the technique carries over, the fasteners and figures on this page are the ones for your car.
How to change license plate light bulbs on VW PASSAT B6
Other VW procedures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.