Removing electrical contact in solar roof — VW
Removing electrical contact in solar roof on VW: 5 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Passat B7 saloon (362, 2010–2014), VW Passat B7 Variant (365, 2010–2014)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 2 Nm (1.5 lb-ft) | Specified torque for bolt (2 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Removing the sliding/tilting sunroof solar panel .
- Put the solar panel down with the top on a non-scratch surface.
- Remove bolt (2) and withdraw contact (1) in (direction of arrow) from guide.
- Pull connector (3) off contact.
- Specified torque for bolt (2): 2 Nm. — 2 Nm (1.5 lb-ft)
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing fuel delivery unit, front-wheel drive, engine codes CAYD, CAYE, CFHC, CFHE, CFHF, CLCA, CFJA
- Checking voltage supply and current consumption of fuel system pressurisation pump G6 engine codes BJB, BLS, BSU, BDJ, BST, BMM
- Removing and installing natural gas tanks 3 and 4
- Sealing upper and lower covers
- Removing and installing fuel tank, engine codes AXA, BDL, BKK
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.