Removing and installing windscreen wiper system: VW Tiguan I

🧭 Before you start

Fits: VW Tiguan I (5N, 2007–2016)

📋 Procedure

1. ⚠ To disconnect and reconnect the battery, the procedure described in the workshop manual should be strictly adhered to . — Deactivate APP function .
2. All wiper arms to move to park position and then switch off ignition.
3. Disconnect battery .
4. Removing wiper arms .
5. Remove plenum chamber cover General body repairs, exterior66Mouldings and trims; Removing and installing plenum chamber cover

6. Release connector (1) and pull off.
7. Undo and remove securing bolts (arrows) and remove wiper frame with linkage and wiper motor (2) sideways out of vehicle.
8. Insert wiper frame with linkage and wiper motor into plenum chamber.
9. On installation, insert guide pin (2) of wiper frame into rubber grommet (1) in plenum chamber bulkhead.
10. Screw in securing bolts (arrows) and tighten to torque specified in assembly overview .
11. Push connector (1) onto connection on wiper motor so that connector latches into place.
12. Install plenum chamber cover General body repairs, exterior66Mouldings and trims; Removing and installing plenum chamber cover
13. Connecting battery .
14. Install wiper arms .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing mounting bracket on driver side · 1 torque figures
• Removing and installing mounting bracket on front passenger side · 1 torque figures
• Installing CSC roof
• Installing Bowden cables for sunroof blind · 1 torque figures
• Removing roof side member flap