Installing CSC roof — VW

🧭 Before you start

Fits: platform code 1F7

Don't miss

• Now insert bolts (2) for main hinge (1), but do not tighten.
• Oil level in reservoir must be between "“min”" and "“max”" marks. Do not fill to "“max”" mark.
• Fault memory must be read using vehicle diagnostic, testing and information systemVAS 5051B to check the electrical components, and must then be erased if necessary.
• After installing roof, perform basic settings .

📋 Procedure

1. Lower roof (arrow a) into vehicle until roof can be guided, together with roof side member, into latch bearing on windscreen frame (arrow b).
2. Only now lower rear of roof (arrow c) until main hinges can be guided into mounting pins.
3. Now insert bolts (2) for main hinge (1), but do not tighten.
4. Guide the gauge for main bearingVAS 6371 with the stops (1) between the mounting pins (2)(arrow a).
5. Lower the gauge for main bearingVAS 6371 onto the main hinge (4) and turn pins (3) of gauge until they slip into the mounting holes (arrow b). [Note: Oil level in reservoir must be between "“min”" and "“max”" marks. Do not fill to "“max”" mark.]

6. Now tighten bolts (2) for main hinge (1).
7. Reconnect hydraulic lines.
8. After reconnecting hydraulic lines, top-up with oil so that the oil level is between the "“min”" and "“max”" markings.
9. Reconnect all disconnected connectors.
10. Connect water drain hoses.
11. Fault memory must be read using vehicle diagnostic, testing and information systemVAS 5051B to check the electrical components, and must then be erased if necessary.
12. Open and close roof once complete, using convertible roof actuation button.
13. After installing roof, perform basic settings .
14. Perform a functional check of roof and side windows after completing basic settings. Adjust side windows if necessary.
15. Check oil level. Top-up with oil so that the oil level is between the "“min”" and "“max”" markings.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing centre console, centre console without armrest · 3 torque figures
• Installing after renewing A-pillar – VW Tiguan I · 4 torque figures
• Removing and installing injectors, Continental – VW CYVB/CYVD · 1 torque figures
• Removing and installing brake booster, left-hand drive
• Removing and installing brake master cylinder, RHD vehicles