Removing and installing voltage stabiliser J532, left-hand drive vehicles — VW
Removing and installing voltage stabiliser J532, left-hand drive vehicles on VW: 5 steps, 2 torque figures.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Touareg II (7P, 2010–2018)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 1.5 Nm (1.1 lb-ft) | Tighten plastic nuts (arrows) |
| 6 Nm (4.4 lb-ft) | Tighten the two nuts securing the voltage stabiliser to the bracket |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove glove compartment General body repairs, interior68Compartments, covers and trims; Removing and installing glove compartment.
- Lift the insulation mat behind the glove compartment.
- Unscrew the two securing nuts (arrows) and take the voltage stabiliser J532(1) off the bracket.
- Release and disconnect connector and remove voltage stabiliser J532.
- Tighten the two nuts securing the voltage stabiliser to the bracket to 6 Nm. — 6 Nm (4.4 lb-ft)
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing selector mechanism with selector lever up to 02.2009
- Removing and installing side airbag crash sensor on driver side G283 (Golf estate 2010 ► - USA) · 2 torque figures
- Checking delivery rate - engine codes CAWB, CBFA, CCTA
- Complaints regarding clutch and clutch mechanism
- Checking throttle valve control part
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.