Removing and installing voltage stabiliser J532, left-hand drive — VW
Removing and installing voltage stabiliser J532, left-hand drive on VW: 5 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Golf VI (5K, 2008–2013)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 1.5 Nm (1.1 lb-ft) | Tighten plastic nuts |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove glove compartment General body repairs, interior68Compartments, covers and trims; Removing and installing glove compartment.
- Unscrew both plastic nuts (arrows) and remove voltage stabiliser J532(2) together with bracket (1) from securing threads, taking connected wiring length into consideration.
- Release and disconnect connector (3).
- Pull ignition/starter switch J532(2) out of bracket (1).
- Tighten plastic nuts to 1.5 Nm. — 1.5 Nm (1.1 lb-ft)
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Dismantling and assembling output shaft (pinion shaft)
- Dismantling and assembling pinion shaft and hollow shaft through gearbox date 22 06 3
- Removing and installing electric drive motor V141
- Removing and installing gearbox - vehicles with V6 TDI
- Checking the Throttle Valve Control Unit – VW 2.3 AGL
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.