Removing and installing vibration damper (engine code BWS) — VW

🧭 Before you start

Fits: VW Passat B6 (3C, 2005–2010)

• Renewed: vibration damper

🔧 Engine codes this applies to

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove poly V-belt .
2. Lock vibration damper using counterhold T10172.
3. Unscrew securing bolts and remove vibration damper from crankshaft journal.
4. ⚠ Check rubber joint between inner and outer ring of vibration damper for cracks and separation. If rubber joint is damaged, renew vibration damper. — Renew securing bolt for vibration damper.
5. Fit vibration damper and tighten bolts by hand.
6. Lock vibration damper using counterhold T10172.
7. Tighten securing bolts. Specified torque: 60 Nm + 1/2 turn (180°). — 60 Nm (44 lb-ft)
8. Install poly V-belt .

Other VW procedures

• Separating exhaust pipes, silencers · 4 torque figures
• Removing and installing rear final drive - Golf 2009 ►
• Removing mechatronic unit · 2 torque figures
• Removing and installing sender wheel · 4 torque figures
• Renewing seals on injectors – VW Jetta VI · 2 torque figures
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures