Removing and installing telephone operating electronics control unit ► 06.2006 — VW

🧭 Before you start

Fits: platform code 1F7

📋 Procedure

1. Switch off ignition and all electrical consumers and remove ignition key.
2. Remove front right seat General body repairs, interior72Seat frames; Front seat; Removing and installing front seat.
3. Unclip cover from sill panel.
4. Unclip cover in front right footwell.
5. Pull carpet up in area of seat and fold over as far as possible towards centre console. Telephone operating electronics control unit can now be seen next to seat coupling station.

6. Unclip both plastic lugs (1) in (direction of arrow).
7. Remove control unit (arrow) with cables connected.
8. Actuate locking mechanism (arrow) on red connector and disconnect connector.
9. Actuate locking mechanism (A) on black connector and fold bow in direction of arrow (B).
10. Disconnect connector.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing upper C-pillar trim (Estate)
• Removing left drive shaft:
• Removing and installing upper D-pillar trim – VW
• Removing and installing rear lid trim 06.00 ▸ – VW
• Removing cover and padding – VW Sharan I / SEAT Alhambra