Removing and installing supplementary fuel pump V393 or fuel pump 2V277 (inline electronic fuel pump), engine code CFHC — VW

🧭 Before you start

Fits: VW Golf Cabriolet (517, 2011–2016)

🔧 Engine codes this applies to

📋 Procedure

1. Release connector (1) and pull off.
2. Remove bolt (2).
3. Remove bracket for exhaust gas pressure sensor 1G450 or pressure differential sender G505 including sensor by pushing in direction of travel (forwards).
4. Release connector (A) and pull off.
5. Unclip fuel hose (B) from retainer.

6. Open fuel hose clip and pull hose (6) off fuel filter.
7. Release and pull connector off fuel temperature sender G81(arrow).
8. Open clip (1) and pull fuel supply line off high pressure pump.
9. Remove bolts (arrows).
10. Remove supplementary fuel pump V393 or fuel pump 2V277.

Other VW procedures

• Installing 4/2-way valve with thermostat – VW 2.0 TDI · 2 torque figures
• Measuring radial clearance of conrods – VW Touareg II · 4 torque figures
• Checking exhaust gas recirculation cooler for leaks
• Installing a previously used balancer shaft module again · 3 torque figures
• Removing and installing engine control unit J623 with protective housing · 1 torque figures
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures