Removing and installing starterB, 2.0 l TSI engine, 155 kW, manual gearbox MQ350-6F — VW

🧭 Before you start

Fits: VW Passat B7 saloon (362, 2010–2014), VW Passat B7 Variant (365, 2010–2014)

📋 Procedure

1. Disconnect battery .
2. Unfasten connector (1) and disconnect.
3. Loosen spring-type clip (2) using spring-type clip pliersVAS 5024.
4. Release locking lug (arrow) and remove cover.
5. Pull hose (arrow) off air filter housing and remove from vehicle.

6. Unscrew securing bolt (arrow) of air filter housing.
7. Pull air filter housing upwards out of rubber mountings and remove it from vehicle.
8. Push protective cap (1) downwards off solenoid switch in (direction of arrow).
9. Unlock connector (1) of terminal 50 and disconnect.
10. Unscrew nut (2) and remove positive cable (3) from solenoid switch.
11. Remove upper securing bolt of starter (arrow).
12. Remove noise insulation General body repairs, exterior66Noise insulation; Removing and installing noise insulation.
13. Undo nut (1) and remove it from lower securing bolt of starter.
14. Remove cable retainer (2).
15. Unscrew starter securing bolt (arrow).
16. Remove starter downwards from vehicle.
17. Tighten threaded connections to torque specified in assembly overview .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing engine (Golf, Golf Plus) – VW 1.9 TDI · 1 torque figures
• Checking fuel pressure, engine codes CDLG, CAVB, CAVC, CAVD, CBZA, CBZB, CTHD, CTKA
• Checking holding pressure, engine codes CDLG, CAVB, CAVC, CAVD, CBZA, CBZB, CTHD, CTKA
• Removing and installing coolant pipes on heat exchanger – VW · 3 torque figures
• Removing and installing backrest release mechanism · 3 torque figures