Removing and installing starterB, 2.0 l TSI engine, 155 kW, dual clutch gearbox DQ250-6F — VW

🧭 Before you start

Fits: VW Passat B7 saloon (362, 2010–2014), VW Passat B7 Variant (365, 2010–2014)

📋 Procedure

1. Disconnect battery .
2. Unfasten connector (1) and disconnect.
3. Loosen spring-type clip (2) using spring-type clip pliersVAS 5024.
4. Release locking lug (arrow) and remove cover.
5. Pull hose (arrow) off air filter housing and remove from vehicle.

6. Unscrew securing bolt (arrow) of air filter housing.
7. Pull air filter housing upwards out of rubber mountings and remove it from vehicle.
8. Push protective cap off solenoid switch downwards in direction of (arrow).
9. Unbolt positive wire (1) and detach connector of terminal 50 (2).
10. Remove upper securing bolt of starter (arrow).
11. Remove lower securing bolt of starter (arrow).
12. Remove starter upwards from vehicle.
13. Tighten threaded connections to torque specified in assembly overview .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Checking clutch lining of torque converter clutch – VW Phaeton · 1 torque figures
• Checking torque converter lock-up clutch – VW
• Removing and installing vane pump, 6-cylinder diesel engine from model year 2009
• Removing and installing starter, 12-cylinder petrol engine, automatic gearbox
• Removing sliding headliner – VW Touran I · 1 torque figures